If I add for instance an WMI or SNMP CPU Load Sensor, does the Sensor goes in Down-State automatically at specific value or do I have to set an Limit always?
Sensor "auto-down"
Votes:
0
1 Reply
Accepted Answer
Votes:
0
Setting Sensor Limits
Disk Space sensors are created with default limits enabled, most other sensors do not have default limits on creation. However, you can set upper and lower warning and error limits for every sensor type in the sensor's Channels tab.
You can create sensors with pre-configured limits using cloning or device templates, and you can also use multi-edit to set limits for multiple sensors at once.
For detailed information, please see:
Created on Oct 28, 2011 11:42:28 AM by
Last change on Oct 28, 2011 11:43:49 AM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment