New Question
 
 
PRTG Network Monitor

Intuitive to Use.
Easy to manage.

200.000 administrators have chosen PRTG to monitor their network. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free PRTG
Download >>

 

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

 

Top Tags


View all Tags


ICMP Error #11010

Votes:

0

Your Vote:

Up

Down

I am getting frequently warning messages "Request Time OUT (ICMP Error #11010)"

ping prtg-network-monitor wmi-process-sensor

Created on Nov 15, 2010 11:17:35 AM by  ArvindSisodia (0) 1



1 Reply

Votes:

0

Your Vote:

Up

Down

Hello,

supposing you are referring to a Ping-Sensor, this means that the Ping sensor was not able to reach the specified target. This can have several reasons (bad connection, flood-protection, routing problems, etc.). You could try to increase the "Ping Count" in the Settings-Tab of the sensor, this helps with packet loss (the sensor will not go into an error-state if 2 of 10 ping packets per scan are lost). Another option is to use a higher timeout, this would help with a slow connection.

Best Regards.

Created on Nov 15, 2010 2:13:53 PM by  Torsten Lindner [Paessler Support]



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.