What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags

View all Tags

How can I change Down (Partial) in Cluster single-failover mode to appear as Down only when both MAS



I only want Down alarms to appear if both MASTER and SLAVE (fail-over) NODES are offline/unreachable/down.

Can this be done?



alarmstate clustering partial-down

Created on Feb 2, 2011 5:25:26 PM

1 Reply



Dear Chris,

as for notifications, 'DOWN'-State Triggers should only react for proper Down sensors not partially down sensors. As for the alarms list in the PRTG webinterface, you could basically simply adjust the URL used, to


Best Regards.

Created on Feb 3, 2011 12:35:45 PM by  Torsten Lindner [Paessler Support]

Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.