Recently we came across a couple devices where the Dependency field says "Object not found". I assume this means that whatever device/sensor this was once dependent on no longer exists. Can you verify that or give me an accurate explanation? Also, when this is the case, does the device still function as it should, only with no dependency?
Dependency "Object Not Found"
Votes:
0
1 Reply
Votes:
0
Dear Scott,
your two 'guesses' are both correct, so it's basically just not exactly correctly displayed. This will likely be addressed with PRTG 9. Please bear with us.
Best Regards.
Created on Apr 1, 2011 3:11:32 PM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment