We have a probe on a site that sometimes goes down, and it has noting to do with the remoteprobe. There is something on the network thats playing with us. So when the remote probes is disconnected, we need to get an alarm about that. How to do it? Havent found any solution.
Send alarm when remote probe goes down
Votes:
0
1 Reply
Votes:
0
Hello,
you would have to setup a State Trigger on the according "Probe Health"-Sensor. That should then alarm you if this probe gets disconnected.
best regards.
Created on Apr 4, 2011 1:10:46 PM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment