What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

How can I change the value in snmp memory report

Votes:

0

I have made a report for cisco switches, using th following snmp sensors: Cpu Load and Free I/O Memory. How can I change the view in the memory sensor, to show percentile used memory, instead of kb free memory. The cpu load is ok showing percent of cpu load.

Or is it possible to make a sensor for snmp memory, like the sensor, Available memory used for servers using WMI.

Where is the html file located in the programfiles, that contains the settings for the I/O memorysensor?

prtg reports snmp-sensor

Created on Apr 13, 2011 1:53:29 PM



1 Reply

Votes:

0

Hello,

you would need to use the sensor factory to calculate the free percentage of the memory: https://www.paessler.com/manuals/prtg8/sensor_factory_sensor.htm

best regards.

Created on Apr 14, 2011 12:58:14 PM by Torsten Lindner [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.