What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Prtgadmin Network Monitor

Votes:

0

Hi, i would like to know if it's possible to filter a report based on ip address ? Since i have a sensor with sniffer on , i can see all kinds of info regarding the protocols , ip addresses and so on but what i would like to do is create a report based on ip address which i'm intrested to how much www traffic was created

kind regards, Fei

prtg sniffer www

Created on Apr 13, 2011 3:07:52 PM



1 Reply

Votes:

0

Hello,

you would need to use a Custom Packet Sniffer to first monitor the traffic of certain IPs. Then you can report upon this sensor (as Toplists can't be reported).

Best Regards.

Created on Apr 14, 2011 1:00:27 PM by  Torsten Lindner [Paessler Support]

Last change on Dec 2, 2021 10:22:24 AM by  Maike Guba [Paessler Support] (2,404) 2 1




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.