New Question
 
 
PRTG Network Monitor

Intuitive to Use.
Easy to manage.

200.000 administrators have chosen PRTG to monitor their network. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free PRTG
Download >>

 

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

 

Top Tags


View all Tags


Should the "traffic in" on one side of a point-to-point T1 equal the "traffic out" on the other?

Votes:

0

Your Vote:

Up

Down

I have an issue with my T1 point to point and slow traffic. I have a Rici T1 Ethernet converter at each end. while looking at the data over a period of time I see that the in on the T1 side aand the out on side b are not even close to equal. over a typical period the data out is 19 kbit/s and 201,800 kbytes total in data is 179 kbit/s and 1,866,000 kbytes total.

ethernet prtg t1

Created on May 12, 2011 9:37:56 PM by  Jim Fuentes (0) 1

Last change on May 16, 2011 2:22:32 PM by  Daniel Zobel [Paessler Support]



1 Reply

Accepted Answer

Votes:

0

Your Vote:

Up

Down

Dear Jim,

if the sensors really monitor the two endpoints of one connection the traffic should be very similar, if of course the sensors have the same settings.

best regards.

Created on May 13, 2011 12:33:33 PM by  Torsten Lindner [Paessler Support]



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.