What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

How can i display CMC information?

Votes:

0

Hello,

we are using Dell PowerEdge 1000e. For these Dell 100e we are using the Dell CMC (Chassis Management Controller) for checking the system status (e.g. Temperature, Power,...). Is it possible to import these information into the PRTG?

I don´t found an information in DELL and Paessler KB.

Best Regards Mike

cmc dell prtg

Created on Jul 22, 2011 2:39:33 PM



4 Replies

Votes:

0

only if the chassis supports SNMP.

does Dell offer some MIBs for it?

Created on Jul 24, 2011 8:23:00 AM by Aurelio Lombardi [Paessler Support]



Votes:

0

OK,

it works.

I have download the MIB´s from Dell and imported it with the Paessler MIB Importer.

Important: For using the Dell MIB´s you will use the SNMP v2.0 Stabndard.

Bets Regards Mike

Created on Jul 25, 2011 8:48:28 AM



Votes:

0

Which MIB did you use so you can see current temp, power usage, etc? The one I have tried just provides a status number and not the actual values.

Created on Apr 18, 2013 1:03:49 PM



Votes:

0

Matt, please be aware that in PRTG 13, there is a SNMP Dell PowerEdge System Health Sensor available (the missing manual page should "appear soon"). Did you try this one already?

Created on Apr 18, 2013 3:59:54 PM by Torsten Lindner [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.