What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

SNMP problem on interface with the traffic of more than 3,500Mbit/s(IN)

Votes:

0

Hello, I have a device with an interface through which a 3500Mbit / s of inbound traffic. Upon reaching the value of a 3500Mbit / s, PRTG 8.4.2.2381 begins to show no valid data, namely the relatively low values ​​of real data. Options:
SNMP - B2
Overflow values ​​- Retry (recommended)
Zero values ​​- Ignore zero values ​​for delta sensors (recommended)
32-bit/64-bit counters - Use 64-bit counters if available (recommended)
The device - CIsco 7609s

big-traffic cisco interface snmpv2c

Created on Jul 26, 2011 10:17:35 AM

Last change on Jul 26, 2011 2:05:45 PM by Torsten Lindner [Paessler Support]



1 Reply

Votes:

0

Dear Andrey,

just to check it's SNMP v2c? Was the sensor added with SNMP v2c set? (You can quickly add a new one, just to test, if it shows the same numbers as the old sensor).

best regards.

Created on Jul 26, 2011 2:06:59 PM by Torsten Lindner [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.