What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

WMI Event Log shows status of Notify

Votes:

0

WMI Event Log Sensor monitoring Application log for Event ID 4113 has a status of Notify but this is the message: Database redundancy health check failed. Database copy: NAIC-MDB1 Redundancy count: 0 Error: Passive copy 'NAIC-MDB1\EXCH1' is not in a good state. Status: ServiceDown. Passive copy 'NAIC-MDB1\EXCH2' is not in a good state. Status: ServiceDown. Passive copy 'NAIC-MDB1\EXCH3' is not in a good state. Status: FailedAndSuspended. Name Status RealCopyQueu InspectorQue ReplayQueue CIState e ue ---- ------ ------------ ------------ ----------- ------- NAIC-MDB1\EXC ServiceDown 0 0 0 Unknown H1 NAIC-MDB1\EXC ServiceDown 0 0 0 Unknown H2 NAIC-MDB1\EXC FailedAndSusp 318966 0 0 Failed H3 ended.

My state triggers only allow for DOWN, WARNING or UNUSUAL - how do I code this to send an alert?

exchange-2010 status wmi

Created on Sep 12, 2011 7:20:20 PM



1 Reply

Votes:

0

Hello,

you would have to set the sensors filtering options that it only catches this event and then you can use the Error-Limits (set a upper limit to 0) which will then switch the sensor into error state once it detects such an event. This could then be used with a State Trigger on Condition Down/Warning (depending on the used limit).

best regards.

Created on Sep 13, 2011 12:39:08 PM by Torsten Lindner [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.