How can I acknowledge the unusual status of all my sensor? i would like to reset the unusual sensor to normal sensor once checked the problem.
Created on Oct 7, 2011 3:13:36 PM by
3 Replies
Accepted Answer
Dear Lorenzo,
I'm afraid the unusual state cannot be acknowledged. You can only try to change the "aggressiveness" of the Unusual Detection in the Monitoring-Settings ("System & Website" in previous versions), or disable the unusual detection on the parent group of this particular sensor(s).
best regards.
Created on Oct 7, 2011 3:16:56 PM by
Last change on May 23, 2014 1:57:27 PM by
Gibt es bis heute keine Funktionalität, um ungewöhnliche Werte Sensoren zu bestätigen? Es wäre eine enorme Erleichterung Fehler im Netzwerk zu analysieren.
Created on Apr 29, 2019 9:57:11 AM by
Dear Dmitrii, thank you for the reply. For the sake of continuity I'm replying in English again. Seeing as there have been no further requests here for over 8 years, it wasn't implemented. Time itself alone isn't an implementation decider for us. Also complexity and number of users who benefit from an implementation should play a role, and for the later, there should be significant numbers of requests. That wasn't the case here I'm afraid.
Created on Apr 29, 2019 1:05:06 PM by
Please log in or register to enter your reply.
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment