What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

How can I monitor bandwidth on HP Virtual Connect 8Gb 20-Port Fibre Channel Module

Votes:

0

Your Vote:

Up

Down

I already tried the SNMP Traffic sensor and it shows only the management port. (also played with the SNMP Settings of the Switch) The switch offers SMI-S too, can I use it?

fc fibre-channel snmp virtual-connect

Created on Oct 10, 2011 6:21:50 AM by  Benutai (0) 1



3 Replies

Votes:

0

Your Vote:

Up

Down

Hello,

please use our SNMP Tester to "scan available standard interfaces" against the target switch. Do you then see all interfaces (with different settings, SNMP version, etc.)?

best regards.

Created on Oct 10, 2011 1:33:14 PM by  Torsten Lindner [Paessler Support]



Votes:

0

Your Vote:

Up

Down

Hello Mr. Lindner,

Here the result (tried different settings):

Found standard interfaces:
1: (001) eth0,Connected,100 MBit/s,Ethernet,
2: (002) lo,Connected,10 MBit/s,Software Loopback,

I also tried to figure out which MIB can be used to convert to a OID and had no luck: http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?swItem=MTX-722ee8c388c04a469c24ff60df&taskId=135&swLang=8&lang=en&cc=us&mode=3&

best regards

Created on Oct 12, 2011 6:44:35 AM by  Benutai (0) 1

Last change on Oct 12, 2011 6:06:50 PM by  Torsten Lindner [Paessler Support]



Votes:

0

Your Vote:

Up

Down

If the tester also only reports these two interfaces then PRTG can't find the other interfaces. Please consult with the vendor if there are actually SNMP counters for those interfaces.

Created on Oct 12, 2011 6:08:09 PM by  Torsten Lindner [Paessler Support]



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.