What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

How to construct dependence of a sensor on two others

Votes:

0

Hello everyone! There was a necessity to switch a sensor in a pause at transition in critical two sensors, for example availability of the server depends on availability two Internet of channels. How it can be made?

thanks

dependency prtg sensor

Created on Oct 24, 2011 9:18:50 AM



2 Replies

Votes:

0

Hello,

this can only be done in PRTG 9. The key would be using the improved Sensor Factory, to bring in both 2 "source sensors" and then setup a Status Formula in the Sensor Factory which will configure the Factory Sensor to only go into error-state if both source sensors go into error state as well (using the "AND" operator).

best regards.

Created on Oct 24, 2011 2:47:39 PM by Torsten Lindner [Paessler Support]



Votes:

0

Thanks

Created on Oct 25, 2011 4:55:06 AM




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.