What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

MPLS Tunnel Virtual Interface

Votes:

0

I have snmp traffic sensors on Brocade CER 2024 MPLS Tunnel Virtual Interfaces but don't see any data. The sensors show green, as connected, but no data.

data prtg9 sensor

Created on May 7, 2012 2:33:33 PM



4 Replies

Votes:

0

Hello,

what happens if you disable the "Ignore Zero Values"-Option (under "SNMP Compatibility Options") in the settings of the parent device to these sensors?

best regards.

Created on May 7, 2012 4:20:16 PM by Torsten Lindner [Paessler Support]



Votes:

0

Made the "Ignore Zero Values" changes and restarted the sensor, still shows zero data. Could it be a MIB issue?

Created on May 9, 2012 11:54:00 AM



Votes:

0

If you then still see 0 values you could scan against the target with our SNMP Tester. Scan twice, with about one minute between the scans and then compare if the counters did change for this very interface.

Created on May 9, 2012 12:30:26 PM by Torsten Lindner [Paessler Support]



Votes:

0

Ran the SNMP Tester twice, 1 minute apart, counters did not change or start showing data.

Created on May 10, 2012 12:24:53 PM




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.