What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

how to disable a single drive showing as down in a sensor for multiple drives

Votes:

0

I have a server that has multiple drives (3 total) however, 1 drive is used for an application that uses the entire disk (this 0MB Free) and I'd like to do one of the following: - Adjust multi-disk sensor so that sensor limits do not apply to the one disk/channel in question.
- Remove the one disk from the multi-disk sensor all together.
- Setup a multi-disk sensor that include only the other 2 drives.

multidisk wmi wmi-free-disk-sensor

Created on May 11, 2012 2:57:56 PM

Last change on May 11, 2012 3:43:17 PM by Torsten Lindner [Paessler Support]



1 Reply

Votes:

0

Hello,

you can disable the Limits for all drives on the Settings-tab of this sensor. Then go into the Channels-tab, there you can:

  • Disable the Channels for "the unwanted drive" from being displayed in data tables & graphs
  • set limits for the other drives again

best regards.

Created on May 11, 2012 3:44:46 PM by Torsten Lindner [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.