What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags

View all Tags

Network team monitoring



Hi, I would like to monitor the throughput of network adapters teamed using the HP teaming software, but the "virtual" adapters do not show in the available adapter list. How do I do this?

network prtg wmi

Created on May 17, 2012 10:25:41 AM

2 Replies



What precise sensor type are you using (WMI, SNMP)?

If the adapters are not showing up automatically, it is highly likely PRTG cannot discern the same at the moment.

Created on May 18, 2012 1:01:28 PM by  Patrick Hutter [Paessler Support] (7,225) 3 3




I have same question, I would like to monitor 3 "virtual" interfaces on HP Proliant, which were created with HP Teaming config tool. When I add Network SNMP Sensor, I can choose all three interfaces, but I get same result for all three, even if I choose different interfaces.

Regards, Luka

Created on Oct 20, 2014 10:08:59 AM

Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.