New Question

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

No such Name (SNMP-Fehler # 2) bei Cisco 1841 Router

Votes:

0

Your Vote:

Up

Down

I monitoring the interface of a cisco 1841 router in a remote office. After a break of the connection or a reboot of the router, I have sometime the failure No such Name (SNMP-Fehler # 2). The only thing I can then do is, to delete the sensor and add it again. I have allready set the "snmp-server ifindex persist" command on the cisco router. The funny thing is, the new sensor has prober the same name then the old sensor. So I'm not understand why this failure appear.

cisco-router prtg snmp

Created on Jun 6, 2012 5:02:24 AM by Roland Altermatt (0) ●1



2 Replies

Votes:

0

Your Vote:

Up

Down

Hello,

please check if the following will help: Automatically update port name and number for SNMP Traffic sensors when the device changes them.

best regards.

Created on Jun 6, 2012 12:31:49 PM by Torsten Lindner [Paessler Support]



Votes:

0

Your Vote:

Up

Down

I will try this. But what I see, the router has not change the Port number or Describtion

Created on Jun 6, 2012 12:45:48 PM by Roland Altermatt (0) ●1



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.