What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Can I be alerted on 2 or more consequetive failures

Votes:

0

Is it possible to be alerted only if sensor was down for 2 out of 2 pulls or something similar?

consequtive failure prtg sensor

Created on Apr 14, 2010 1:45:43 PM

Last change on Apr 15, 2010 9:26:50 AM by Daniel Zobel [Product Manager]



1 Reply

Accepted Answer

Votes:

0

Please consider using a Latency in the Notification Trigger settings. If a latency is set for a trigger, a notification will only be sent if the condition causing the notification still exists after the seconds specified.

For example, if you set the latency for a trigger to 60 seconds, the notification will only be sent if the failure situation remains active for 61 seconds. See manual section Notifications for more information.

Created on Apr 14, 2010 2:20:36 PM by Daniel Zobel [Product Manager]

Last change on Apr 14, 2010 2:24:51 PM by Daniel Zobel [Product Manager]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.