I want to monitor NetApp via SNMP. However, I get an error message saying
No Such Name (SNMP error # 2)
What can I do?
Created on Aug 10, 2012 3:16:06 PM by
No Such Name (SNMP error # 2) for NetApp Sensors
Votes:
0
3 Replies
Accepted Answer
Votes:
0
This article applies to PRTG Network Monitor 12.3 or later
Use SNMP version 2c For NetApp Monitoring
To our experience, a NetApp does not provide all counters via SNMP v1. This results in the error message quoted above.
In order to receive all counters in your NetApp sensors, please change the SNMP version from v1 to v2c. You can do this in the PRTG web interface in the Settings tab of the device which represents your NetApp.
Created on Aug 10, 2012 3:19:01 PM by
Votes:
0
When you use our SNMP tester and do a walk on the OID 1.3.6.1.4.1.789.1, what results do you get? Can you post the log files from the tester?
Created on Jan 26, 2016 3:42:37 PM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment