If I bought a 1000 sensors license. Do the number of sensors share between master & failover node and can we use the the failover node to monitor the devices of it own subnet ?
Failover node
Votes:
0
8 Replies
Votes:
0
Hello,
in a PRTG Cluster the sensors are basically shared between the nodes, there is no real splitting. It depends. If you move all the sensors under the Cluster Probe, you will have 1000 Sensors on master and failover (all sensors monitored all the time). If you keep 500 sensors on the Local Probe on the Master and have the other 500 under the Cluster Probe, you will only "see" those 2nd 500 on the failover. Ideally though all sensors should be accessible from all nodes in your cluster.
best regards.
Created on Aug 14, 2012 3:55:18 PM by
Votes:
0
For a 4-node-cluster you'll need two licenses of the same type (as each license supports 2 nodes).
Created on Aug 15, 2012 12:05:20 PM by
Votes:
0
Again, the licenses should be the same. So the same size.
Created on Aug 15, 2012 2:36:11 PM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment