New Question

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Can't Get SNMP Port Traffic from Cisco SF-300-08

Votes:

0

Your Vote:

Up

Down

The auto discovery seems to find the ports but doesn't get any information. I see a "no such name" error. I had it working not too long ago but had to reset and reconfigure. So, I know that it will work (or did work). A simple Cisco switch SF-300-08.

no-such-name prtg snmp-sensor

Created on Aug 24, 2012 7:32:03 PM by Fred Marshall (0) ●1



1 Reply

Votes:

0

Your Vote:

Up

Down

Hello,

could it be that the interface numbers did change upon the reset of the target device? Can you add the sensors manually again?

best regards.

Created on Aug 27, 2012 11:11:12 AM by Torsten Lindner [Paessler Support]



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.