Where can I find articles regarding a cluster setup?
Created on Oct 4, 2012 12:10:54 PM by
I need help with my cluster configuration. Where do I find step-by-step instructions?
Votes:
0
3 Replies
Accepted Answer
Votes:
0
This article applies as of PRTG 22
Help with the cluster
There are several articles available for different scenarios:
- General instructions on the Paessler website:
How to set up a failover cluster in PRTG in 6 steps - Move a master node or failover node installation:
How can I move or migrate my PRTG installation to a different system or server? - Replace a master node if it fails permanently:
Cluster: How do I convert a (temporary) failover master node to be the primary master node? - Start over if you are lost while setting up a cluster:
My cluster is messed up. How can I start over?
Created on Oct 4, 2012 12:18:58 PM by
Last change on Jun 1, 2022 10:58:27 AM by
Votes:
0
All licenses support at least one failover node, including the 100 Sensor version. In Daniel's first reply to the thread, there's the step by step tutorial - this should be what you're looking for :)
Kind regards,
Stephan Linke, Tech Support Team
Created on Jul 2, 2018 7:38:03 PM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment