New Question

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

problem with paused devices

Votes:

0

Your Vote:

Up

Down

PRtg was restarted due to power failuer now most of the devices are paused and give the following message

Sensor Name

(002) eth0 (Sensor not licensed)

i can't resume any devices and if i added any new device it gaves me pause

paused prtg resumed

Created on Nov 18, 2012 12:03:22 PM by Ehab (0) ●1



1 Reply

Votes:

0

Your Vote:

Up

Down

Please either open a support ticket or forward us an email to [email protected] refering to this thread. Please include a screenshot of the "Setup -> PRTG status -> System status" page for analysis.

Created on Nov 19, 2012 2:01:50 PM by Patrick Hutter [Paessler Support] (7,225) ●3 ●3



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.