I'm monitoring a device which is returning a value containing a decimal point. It is counting as an integer but always has a ".0" at the end. Is there any way to change the "PRTG Configuration.dat" file to force this sensor to count the delta value? The values are 1.0 then 2.0 then 3.0 etc.
3 Replies
Please log in or register to enter your reply.
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment