What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

How do I enable and use remote commands in Windows PowerShell?

Votes:

0

A specific sensor in PRTG uses remote commands in Windows PowerShell. How do I enable these remote commands?

hyper-v powershell prtg remote-commands sensor

Created on Dec 7, 2012 10:57:20 AM by  Gerald Schoch [Paessler Support]

Last change on May 6, 2019 11:14:32 AM by  Maike Guba [Paessler Support] (2,404) 2 1



1 Reply

Accepted Answer

Votes:

0

This article applies as of PRTG 22

Enabling and using remote commands in Windows PowerShell

If a sensor, for example the Hyper-V Cluster Shared Volume Disk Free sensor, uses PowerShell commands, you have to enable Remote PowerShell to monitor devices with this sensor.

For more details, see the following article:

Enable and Use Remote Commands in Windows PowerShell

Created on Dec 7, 2012 10:58:21 AM by  Gerald Schoch [Paessler Support]

Last change on Jan 3, 2023 8:13:35 AM by  Brandy Greger [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.