What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags

View all Tags

PRTG Triggers is not working



I have set the triggers to "When Traffic Total channel is Above xxxxx kbit/second for at least 300 seconds perform Email to Admin". But i think when traffic is above xxxxx kbit/s it'll perform send email right now. How can i set the triggers to achieve at least 300 seconds and then perform email? Many THX!!!

email traffic-monitoring triggers

Created on Jan 31, 2013 1:50:56 AM

1 Reply




can you please upload three screenshots showing:

  • The Notification-Tab on the sensor, showing the Trigger.
  • The Log-Tab of the sensor this refers to.
  • The notification email that was triggered.

Alternatively, please send the screenshots via email to [email protected]

best regards.

Created on Jan 31, 2013 2:23:36 PM by  Torsten Lindner [Paessler Support]

Last change on Jan 31, 2013 2:24:27 PM by  Torsten Lindner [Paessler Support]

Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.