The error message states "The request was aborted: Could not create SSL/TLS secure channel"
Created on Mar 8, 2013 9:31:01 AM by
When I try to add a Xen sensor, I get an error
Votes:
0
1 Reply
Accepted Answer
Votes:
0
This means, that you did enter wrong credentials in the device settings. Please go to the device settings and enter correct credentials in the category "Credentials for VMware/XenServer".
Created on Mar 8, 2013 9:32:21 AM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment