What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

SNMP Traffic Data over Juniper IPSec Tunnel

Votes:

0

I have a few offices that are connected via Junniper site-to-site IPSec tunnel. I am unable to get them to respond to SNMP requests by PRTG.

juniper netscreen snmp

Created on Mar 28, 2013 6:42:36 PM



5 Replies

Votes:

0

Have you tried connecting with our SNMP Tester? Does that yield results?

Created on Mar 28, 2013 6:52:21 PM by Patrick Hutter [Paessler Support] (7,225) ●3 ●3



Votes:

0

I did. No response. I verified the tool was working by connecting to another device. It responded right away.

Created on Mar 28, 2013 6:59:33 PM



Votes:

0

In that case, it would seem that either SNMP isn't activated or not available (which could have to do with the community string, port settings, etc.). If you run an Uptime test with the Tester, does that yield any results?

Created on Mar 29, 2013 9:40:29 AM by Patrick Hutter [Paessler Support] (7,225) ●3 ●3



Votes:

0

I am able to conect to the "outside" interface and collect data, but I cannot get it to respond via the LAN interface.

Created on Apr 1, 2013 4:34:46 PM



Votes:

0

But you are allowed to send SNMP requests to the inside interface?

e.g. on an ASA SNMP configuration you need to select the interface you are allowed to connect to.

Created on Apr 2, 2013 6:22:23 AM by Aurelio Lombardi [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.