What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags

View all Tags

When using a cluster, can I keep the sensor from going red when it's partial down?



I just setup a cluster and I would like to keep the sensors from turning red if one node is unable to reach the device. Is this possible?

cluster down partial-down

Created on Apr 3, 2013 12:39:21 AM

1 Reply



no, this is not possible due to the cluster architecture. Sorry. Best regards

Created on Apr 3, 2013 6:32:47 AM by  Konstantin Wolff [Paessler Support]

Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.