The incoming data from WMI Logical Disk Sensor is quite low and do not exceed 0,03 value. So good idea is to use scale on this sensor, but i can't find such option in Settings tab, where according to manual it must be. PRTG Network Monitor 13.1.2.1383
Where is "Scale" option in WMI Logical Disk Sensor?
Votes:
0
1 Reply
Accepted Answer
Votes:
0
Unfortunately, scaling is not available for this sensor. This is for internal technical reasons.
As a workaround we recommend you use a Sensor Factory sensor to "replicate" your sensor. Scaling is available for sensor factory sensors.
Created on Apr 30, 2013 2:56:33 PM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment