What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

How can I modify "Bandwidth Traffic IN and Bandwidth Traffic Out" ?

Votes:

0

After restarting PRTG Server - I've noticed that "Bandwidth Traffic IN and Bandwidth Traffic Out" of some PC's has changed to high amount of "Bandwidth".

Before it was normally has the Bandwidth Traffic IN and OUT of 300 kbits/second but now it became to 1,500 kbytes/seconds or morethan.

What should I do to get it back to normal Bandwidth Traffic..? Hope my question and how I describe it was clear enough.

Thank you.

bandwidth prtg traffic

Created on Apr 27, 2013 11:37:02 AM



1 Reply

Votes:

0

It could be that this sensor had a spike in data and that has set the maximum value higher for these sensors. You could delete these sensors or clone them to create a new sensor without these spikes then set those channels to ignore spikes.

Filter Spikes From Graphs in PRTG

Created on Apr 29, 2013 11:44:32 AM by Greg Campion [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.