Hi, In PRTG6 it's possible to create a sensor in "add sensor" with type "sensor Aggregation". With and Aggregation Sensor you can add up the data of two or more sensors and create a new sensor with the aggregated readings. How i can do this in PRTG9?. For exemple to monitor traffic for a set of ports in a switch. Thanks a lot.
Sensor Aggregation
Votes:
0
1 Reply
Votes:
0
Hi,
for this purpose in PRTG 9 you might want to have a look at the Sensor Factory Sensor. It has the same functionality than the sensor aggregation in PRTG 6.
Best regards
Created on May 21, 2013 5:58:47 PM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment