Is it possible to automatically combine PDF's for scheduled 'Data Table 24h' PRTG reports rather than getting a seperate PDF for each sensor I'd like to monitor? Thanks, regards.
Combine PDF Report for Multiple Sensors?
Votes:
0
1 Reply
Votes:
0
Dear Steve,
the reason is the following (and the issue as such is intended): PRTG splits up PDF reports into multiple parts (since version 7.1.x), as otherwise the PDF-rendering engine might ran out of available memory, if it would have to 'put' too many sensors (with too many historic data) into one PDF file. I'm very much afraid this cannot be changed.
Best Regards.
Created on Jun 7, 2010 1:46:07 PM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment