Do you have a best practice solution to let PRTG now there was a software update on a monitored system and some services were new? It's not a problem if a service is missing after an update because the sensor will went to error state, but if there were some new services we must figure out which services this could be...
Automated process for changed software
Votes:
0
1 Reply
Votes:
0
Hello,
thank you very much for your KB-Post. I'm very much afraid PRTG does not monitor for available updates on target machines. But if services do not start after updates, the sensors (monitoring these services) will be in error state.
best regards.
Created on Jun 21, 2013 8:25:57 AM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment