When setting up a WMI Security Center sensor to monitor Anti-Virus/Security items, in the list it shows the products, and the type is shown on the right. But once the items are selected (or found via autodiscovery), you are no longer able to see the Type the product is. This is a issue when your antivirus product has AntiVirus, AntiSpyware, and Firewall all in the same product. You get the three items all showing the same name, with no way to tell which is which when there is a error status.
WMI Security Center not grabbing Type
Votes:
0
Best Answer
Accepted Answer
Votes:
0
Thank you for your feedback. We do understand the problem and we will add the type to the default sensor name.
In the meantime, if the sensor goes to warning or error state, you can go to the settings and you will find a setting called "Type". This setting is not changeable, but you can see which type the sensor is.
Created on Aug 14, 2013 10:54:10 AM by
3 Replies
Votes:
0
Hello,
thank you very much for your KB-Post. Can you please upload some screenshots showing this? Thank you!
best regards.
Created on Aug 13, 2013 12:19:26 PM by
Accepted Answer
Votes:
0
Thank you for your feedback. We do understand the problem and we will add the type to the default sensor name.
In the meantime, if the sensor goes to warning or error state, you can go to the settings and you will find a setting called "Type". This setting is not changeable, but you can see which type the sensor is.
Created on Aug 14, 2013 10:54:10 AM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment