What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Monitoring APC MasterSwitch via SNMP

Votes:

0

The biggest problem here is that I'm new to SNMP, so forgive me for asking questions that are remedial in nature.

The only sensor I can get PRTG to recognize is PING for this device. Tried to manually add the APC Hardware Sensor and got the following error:

"No available interfaces on this device (code: PE049)"

I launched the SNMP Tester software and pointed it to the IP of my Masterswitch, chose SNMP v1 and set the community string, and the results of the test are below -

----------------------- New Test ----------------------- Paessler SNMP Tester 5.1 12/06/2013 14:14:16 (2 ms) : Device: 10.70.62.50 12/06/2013 14:14:16 (4 ms) : SNMP V1 12/06/2013 14:14:16 (5 ms) : Custom OID 12/06/2013 14:14:18 (2011 ms) : ------- 12/06/2013 14:14:18 (2014 ms) : Value: Error converting OID (SNMP error # -2007) 12/06/2013 14:14:18 (2020 ms) : Done

I'm not sure what to do to get more than just network connectivity (PING) to be reported from this device to PRTG. Any help/direction would be greatly appreciated. Thanks in advance for your time.

prtg13 snmp wmi

Created on Dec 6, 2013 11:17:38 PM



1 Reply

Votes:

0

If you run a "Device Uptime" scan using the SNMP Tester, does that yield a result?

Created on Dec 9, 2013 10:41:36 AM by Patrick Hutter [Paessler Support] (7,225) ●3 ●3




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.