Can prtg capture mac-addresses from port of cisco and put information in log file every 30 minutes?
Capture mac-address
Votes:
0
1 Reply
Accepted Answer
Votes:
0
Hi,
no, this is not possible with native PRTG sensors. However you might write a own script which does the same and run the same using the EXE/Script or the EXE/Script Advanced Sensor.
Best regards
EDIT: If the MAC addresses can be obtained via SNMP as string you might have a look at the SNMP Custom String Sensor as well.
Created on Dec 16, 2013 12:30:15 PM by
Last change on Dec 16, 2013 12:31:49 PM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment