What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

What value does the Transmitted channel of an RMON sensor show?

Votes:

0

How does PRTG interpret the transmitted "kbits per second" in the SNMP RMON sensor’s primary channel? Is it the sum of ingoing and outgoing traffic? Is it comparable to what the SNMP Traffic sensor shows in the Total channel? Or are only octets counted that are received on the monitored interface?

prtg rmon snmp snmp-traffic traffic transmitted

Created on Jan 30, 2014 4:17:37 PM by  Gerald Schoch [Paessler Support]

Last change on Jan 4, 2023 11:51:00 AM by  Brandy Greger [Paessler Support]



1 Reply

Accepted Answer

Votes:

0

This article applies as of PRTG 22

The meaning of the SNMP RMON sensor’s Transmitted channel

The SNMP RMON sensor monitors the traffic on an SNMP-compatible device and can show traffic data for each available port. For this purpose, the sensor uses the RMON MIB. The RFC for this MIB does not specify what is counted in etherStatsOctets, the counter that is used for the Transmitted channel.

We interpret transmitted as total traffic on the device. This corresponds to the sum of the Traffic In plus Traffic Out channels of an SNMP Traffic sensor. Tests on HP switches in our labs confirm this assumption, as well as occasional feedback from our customers (for example, for the 3Com Superstack switches 3200, 3300, and 4400).

Some manufacturers might interpret etherStatsOctets differently. Considering feedback from PRTG users, switches from D-Link (for example, DES-3200, DGS-3100, DGS-3120, DGS-3240, and DWS-4026) only count octets that go into an interface (Traffic in); the same is true for some Allied Telesyn switches (for example, the AT-3850GB).

The value that is shown in the Transmitted channel of the SNMP RMON sensor also highly depends on the interpretation of your switch’s manufacturer. If the producer of your device does not interpret this counter as traffic total, you can manually rename the Transmitted channel to, for example, Received, depending on what is actually counted.

Created on Jan 30, 2014 4:20:39 PM by  Gerald Schoch [Paessler Support]

Last change on Jan 3, 2023 9:48:28 AM by  Brandy Greger [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.