What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Warning and Down Notification

Votes:

0

As per requirement I need to configure a SQL sensor only with Warning Threshold value. But for the notification below condition should be followed

If 6 consecutive warnings Alert have been fired. then PRTG will now send a down Alert every minute

Can anyone help me with this.

prtg prtg8 sqlsensor

Created on Mar 3, 2014 11:25:36 AM



2 Replies

Votes:

0

Hello,

thank you very much for your KB-Post. I'm afraid it's not possible to set time-conditions for state changes on sensors. State Changes will be immediate. The recommendation is to use the error limit directly, and then use a latency, to send a notification only after a certain time (which you consider "critical" then).

best regards.

Created on Mar 4, 2014 10:02:21 AM by Torsten Lindner [Paessler Support]



Votes:

0

Thanks for the answer

Created on Mar 4, 2014 10:36:11 AM




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.