What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Event Log sensor Ajax Error

Votes:

0

Hello, Based on this post: https://www.paessler.com/knowledgebase/en/topic/59803-my-event-log-sensor-ignores-changes-in-the-event-log-what-can-i-do

I have configured the sensor and when I tried to configure the limit I received an error (I couldn't reply to that post so I open a new one).

Ajax Error (Bad Request) 14.1.8.1308 The validation of the data provided failed due to the following: Upper Error Limit (#/s): "0,0001" is not a floating point number.

Please advise.

Regards, Yaron

eventlog eventlog-wmi limits

Created on Mar 3, 2014 8:41:49 PM



2 Replies

Votes:

0

Hi,
have you tried using a dot . as decimal delimiter?
Additional, you might set an upper error limit of 0 as well which will trigger an alert as soon as a Event is recognized.
Best regards

Created on Mar 4, 2014 2:12:34 PM by Konstantin Wolff [Paessler Support]



Votes:

0

Hi,

I copied the value from the example, the example uses a comma and not a dot (0,0001). I was not sure if it would work with a dot, i corrected and there isnt any error message.

Thank you, Yaron

Created on Mar 4, 2014 3:37:31 PM




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.