New Question

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

sensor status mode

Votes:

0

Your Vote:

Up

Down

Hello,

Is it possible to set that a sensor will go into an error/warning status only after a certain period of time?

Thanks, Yaron

notifications sensor status

Created on Mar 9, 2014 9:03:30 AM by YEidelman (2) ●2



2 Replies

Accepted Answer

Votes:

0

Your Vote:

Up

Down

Hello,

thank you very much for your KB-Post. I'm afraid a delay or latency on a status change of a sensor (into warning or error state) is not possible or planned. We believe these changes have to be immediate. Please instead work with the latencies on the notifications.

best regards.

Created on Mar 10, 2014 9:12:32 AM by Torsten Lindner [Paessler Support]



Votes:

0

Your Vote:

Up

Down

Hello,

Thank you for your response.

Regards, Yaron

Created on Mar 10, 2014 1:36:06 PM by YEidelman (2) ●2



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.