New Question

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

How do you configure a sensor to not send a notification when down?

Votes:

0

Your Vote:

Up

Down

We don't want to notify that the SNTP sensor went down or not. How do we configure PRTG for this condition?

Thanks

prtg snmp sntp

Created on May 2, 2014 2:55:37 PM by Nathan Johnson (0) ●1



3 Replies

Votes:

0

Your Vote:

Up

Down

Hello,

thank you very much for your KB-Post. Did you already remove / disable all Triggers on the SNTP-Sensor? That should then prevent any notifications.

best regards

Created on May 6, 2014 11:49:02 AM by Torsten Lindner [Paessler Support]



Votes:

0

Your Vote:

Up

Down

We are very new to PRTG. So where would I do that? Thanks.

Created on May 9, 2014 1:59:05 PM by Nathan Johnson (0) ●1



Votes:

0

Your Vote:

Up

Down

On the Trigger-Tab on the sensor.

Created on May 12, 2014 11:30:10 AM by Torsten Lindner [Paessler Support]



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.