What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

PRTG not working after upgrade to the 114.2.10.2114

Votes:

0

I had stable 600 SNMP sensors setup until i run upgrade to 14.2.10.2114. Right after the upgrade my sensors started going "down" with errors Error opening snmp session: Unknown host (x.x.x.x:161) (Bad file descriptor) (SNMP error # -2006). Then they randomly come back up and go down again. Operations, like Pause/Resume are slow, take good 10-15 minuted to start a sensor. Does anybody else have this issue with new version? To normalize the setup i had to move scanning to 60 minutes, but as i said, this is defiantly related to software upgrade.

Thanks, Sergiy CCIE #28978

14-2-10-2114 descriptor upgrade

Created on May 24, 2014 6:42:33 PM



1 Reply

Votes:

0

Please forward us your query as a support ticket to [email protected]. Please provide a full support bundle, as outlined under Contacting support.

Created on May 26, 2014 9:50:57 AM by Patrick Hutter [Paessler Support] (7,225) ●3 ●3

Last change on May 26, 2014 9:51:21 AM by Patrick Hutter [Paessler Support] (7,225) ●3 ●3




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.