What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general.

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Modify channel names

Votes:

1

I would like to modify the names of the channels that were created while doing an autodiscovery of a Cisco switch. The channels reside under the "System Health Other" sensor, and are currently showing as unmodifable (greyed out, I can modify other settings, however). I'd like to replace the channel names with something more meaningful (i.e. 1040, 1052, etc).

cisco sensor-channel system-health

Created on Jun 12, 2014 9:41:40 PM



1 Reply

Votes:

0

Hello,

thank you very much for the KB-Post. It's not possible to change the Channel Names on those sensors, because they are used internally to identify the actual value for each sensor channel on the target. Sorry.

best regards.

Created on Jun 17, 2014 4:21:38 PM by Torsten Lindner [Paessler Support]




Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.