New Question
 
 
PRTG Network Monitor

Intuitive to Use.
Easy to manage.

200.000 administrators have chosen PRTG to monitor their network. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free PRTG
Download >>

 

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

 

Top Tags


View all Tags


SNMP Cisco ASA VPN status is Down

Votes:

0

Your Vote:

Up

Down

Currntly i am evaluating PRTG. i am facing issue with "SNMP Cisco VPN Sensor"

we have two Cisco ASA device (5510 and 5512) and both ASA's are have 5 active IPSec tunnels each.

PRTG is showing -

IPSec tunnels as UP for 5512 ASA. but, showing IPSec tunnels as DOWN for 5510 ASA.

Message : there is no active connection for this remote ip address. (code - PE123)

ciscoasa snmp-sensor vpn-tunnel

Created on Jun 24, 2014 12:39:49 PM by  Rafi (0) 1



6 Replies

Votes:

0

Your Vote:

Up

Down

Hello,

may I ask, which exact version of PRTG are you running? Could you please upload some screenshots showing the issue? Just to check, you can add the VPN-Sensors on the 5510 but immediately after adding them, they do show this error? Were the sensors manually added or via Auto-Discovery?

best regards.

Created on Jun 26, 2014 7:50:59 AM by  Torsten Lindner [Paessler Support]



Votes:

0

Your Vote:

Up

Down

Thanks for reply. i am using PRTG ver. 14.2.10.2255. it was Auto-Discovery.

i coundn't find any option here to past screenshots!!!

NOTE: PRTG is showing IPSec tunnel status for our other ASA device.

Thanks you

Created on Jun 27, 2014 7:39:57 AM by  Rafi (0) 1



Votes:

0

Your Vote:

Up

Down

Can you please try adding the sensor manually instead? Does it then work?

Created on Jun 27, 2014 7:47:12 AM by  Torsten Lindner [Paessler Support]



Votes:

0

Your Vote:

Up

Down

Yes, i also tried by adding sensor manually but, no luck..

Created on Jun 27, 2014 8:21:29 AM by  Rafi (0) 1



Votes:

0

Your Vote:

Up

Down

Please send us some screenshots showing this issue via email to support@paessler.com we will continue this as a normal ticket then.

Created on Jun 27, 2014 8:29:36 AM by  Torsten Lindner [Paessler Support]



Votes:

0

Your Vote:

Up

Down

Hello,

sent an email with screenshots of errors.

Thanks.

Created on Jun 27, 2014 8:42:59 AM by  Rafi (0) 1



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.