We would like to change the amount of time a device is in the warning state before it goes to an error. Are we able to change this for a group of devices or in the configuration of PRTG?
Can the time setting on the warnings be changed?
Votes:
0
1 Reply
Votes:
0
Hello,
I'm sorry, but is not possible to set timing conditions on state changes for sensors. State changes will always be immediate. Please use the Latencies on Triggers to delay notifications.
best regards.
Created on Jun 27, 2014 8:13:51 AM by
Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Add comment