New Question

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

PRTG Network Monitor

Intuitive to Use. Easy to manage.
More than 500,000 users rely on Paessler PRTG every day. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free Download

Top Tags


View all Tags

Notifications Clear

Votes:

0

Your Vote:

Up

Down

Is it possible to setup a state notification trigger so that is only sends a "state clears" notification if has sent the notification for "When condition continues for at least....."?

I am attempting to set the system to only notify me when a sensor is down for X time, and then only get the clear notification if that down time threshold was reached.

Is this possible?

notification prtg sensor trigger

Created on Jul 1, 2014 3:10:59 PM by Eric Suger (0) ●1



1 Reply

Votes:

0

Your Vote:

Up

Down

Hello,

thank you very much for your KB-Post. I'm very sorry, it's not possible to set a latency on the "When condition clears ..."-part of a trigger.

best regards.

Created on Jul 3, 2014 12:46:29 PM by Torsten Lindner [Paessler Support]



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.