New Question
 
 
PRTG Network Monitor

Intuitive to Use.
Easy to manage.

200.000 administrators have chosen PRTG to monitor their network. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free PRTG
Download >>

 

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

 

Top Tags


View all Tags


Netflow Cisco Router

Votes:

0

Your Vote:

Up

Down

We want to monitor our Cisco routers with NetFlow. The routers will send the data from different locations to our main prtg server over WAN. It is possible to display the sensor below the remote probe of the location or only below the main server? We get our routers preconfigured and it would be a lot easier with one ip adress for the netflow configuration.

cisco netflow wan

Created on Jul 30, 2014 7:26:48 AM by  DanielRudi (0) 1



1 Reply

Votes:

0

Your Vote:

Up

Down

If you send the flow data to the IP of the main server/local probe, then you can only place the netflow sensors somewhere under that probe.

If you need them under the remote probe, you need to configure the devices to send the flows to the remote probe IP.

Created on Jul 31, 2014 12:41:38 PM by  Aurelio Lombardi [Paessler Support]



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.