New Question
 
 
PRTG Network Monitor

Intuitive to Use.
Easy to manage.

200.000 administrators have chosen PRTG to monitor their network. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free PRTG
Download >>

 

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

 

Top Tags


View all Tags


Cisco 6506 current and voltage

Votes:

0

Your Vote:

Up

Down

I have two 6506's and both report about 27ma for current and 0v for voltage. The current sensor is the Current 5012 and the voltage is the Voltage 5011. Both of these readings are below the low threshold and alarming.

Is this an accurate reading and should I be concerned?

Thanks!

6505 cisco system-health-currents voltage

Created on Aug 13, 2014 4:13:52 PM by  TBFL (0) 1



1 Reply

Votes:

0

Your Vote:

Up

Down

Hello,

thank you very much for using PRTG. When PRTG adds this sensor, it asks the target device (the Cisco Device) for critical threshold for each value (channel). These thresholds are then set as Warning & Error-Limits in the Channel Settings of the Sensor. Sometimes the devices return non-sensical values, in those cases please change the limits manually and adjust them to your "needs".

best regards.

Created on Aug 18, 2014 10:59:41 AM by  Torsten Lindner [Paessler Support]



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.